16 Ways to do your natural hair

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately.

Unbraid 1 section and apply Cantu argon oil leave-in conditioner and detangle using a wire brush and your fingers. Then re-braid section and repeat for all other sections.

Using one section, separate hair into four smaller parts. Grabbing one part, split hair into two groups and begin to simply twist your hair from the root. One can either twist inward or outward until a coil is formed. Perform this on all sections of your hair.

Let the hair dry by either waiting overnight or using a blow dryer.

Apply oil to dry hair then begin to untwist hair.

Separate each twist until desired volume is obtained.

Photo from Giphy

After the twist outs curls begin to fall (refer to #1), you can use a pic and comb out hair until desired volume is acquired. Spray with argon oil after hair is fully combed out.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out). Section the hair into 4-6 parts then blow dry. Pic hair to obtain the desired shape and volume.

Photo from Giphy

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out). Separate hair into 4-6 sections and blow dry and braid back into sections. (Note: this can be done on newly washed or already straightened hair.)

Unbraid 1 section and apply Cantu argon oil leave-in conditioner and detangle using a wire brush and your fingers.

Using one section, separate hair into four smaller parts and put into a ponytail using small rubber bands. Repeat for all sections.

For each ponytail, separate into two parts and twist, creating a coil.

After take the entire coil and twist into a knot, twisting counterclockwise.

To secure the knot, use a bobby pin or tuck underneath the knot.

Photo: Giphy

Put hair into a ponytail at the front of your head.

Place one end of fabric at the bottom of your head and pull towards the front. Tie a not.

Grab once end of the fabric and wrap around the ponytail, covering all your hair. Repeat with other end.

Tuck ends of the fabric underneath the already twisted fabric.

Lower head wrap until it sits comfortably.

Photo: myglamosphere.com

First preform a twist out (see #1).

After hair has dried and been uncoiled, section hair into two parts. One at the front of your head (smaller section) and the other being the back of your head.

Using gel and a brush, slick back the front portion of your hair into a bun or ponytail.

Then separate the back twist until desired volume is reached.

Photo: Hairstyleguru.com

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately.

Unbraid 1 section and apply Cantu argon oil leave-in conditioner and detangle using a wire brush and your fingers. Then re-braid section and repeat for all other sections.

Using one section, separate hair into four smaller parts. Grab flex rod and tightly twist hair around the rod. Apply extra product to the ends of the hair and then bend rod so it will stay.

Let dry overnight or use blowdryer.

Untwist hair from Flexi rod when dry and separate each twist until desire volume is reached. Then spray with oil.

Photo: northeastaventures.com

Twist Bun- Apply Eco styling gel to hair and brush into a ponytail using a wire brush. After creating a ponytail, twist hair until it begins to coil around itself (like a cinnamon roll). Tuck the ending of the twist underneath the bun and secure with bobby pin.

Sock Bun- Apply Eco styling gel to hair and brush into a ponytail using a wire brush. After creating a ponytail, place a foam doughnut (can be purchased at a hair store for $3) around the end of your ponytail. Roll the doughnut and your hair down until it reaches the base of the ponytail. Cover there foam completely by moving hair (if needed). Use bobby pins to keep bun secure.

Photo: giphy

Buy hair of desired length.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Cornrow (braid) hair into a spiral ending in the middle of your head. Leaving out the edges and smaller section where you want your part to be.

Remaining hair that is braided, sow using thread into another portion of the braid.

Take the weave and. begin to sow it into the braid starting from the back of your head until you reach the front.

After you are done sowing, straighten the remaining portion of your hair.

Then comb through both the weave and your natural hair.

Photo: giphy

Buy desired length of braiding hair and section into small portions.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Grab a small portion of one section of your real hair and then grab one portion of the weave (separate into 2 pieces= 1/3 & 2/3)

Loop the 2/3 section around the 1/3 section of hair creating an interlocking loop

Place weave over your real hair at the roots and allow natural hair to fall into the middle section of the weave.

Braid your hair in with the weave until braid is completed.

Repeat until full head is braided.

Boil hot water and dip ends of braids into the water so that they will not unravel.

Photo: pinterest

Buy desired length of braiding hair and section into small portions.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Grab a small portion of one section of your real hair and then grab one portion of the weave (separate into 2 pieces= 1/3 & 2/3)

Loop the 2/3 section around the 1/3 section of hair creating an interlocking loop

Place weave over your real hair at the roots and allow natural hair to fall into the middle section of the weave.

Twist both the weave and natural hair together until the entire section is twisted.

Repeat until entire head is finished.

Boil hot water and dip ends of twist in water.

Photo: Giphy

Buy desired length of faux locs and braiding hair and section into small portions.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Section entire head into small sections and braid each one.

Using a crochet hook, place hook through the a braid and attach the faux loc and a small portion of the braiding hair.

Use the braiding hair to wrap around the braid and the faux loc to create a new loc.

Using a lighter, light the ends of the loc until it begins to melt together then graze the lighter against the rest of the loc.

Repeat until the entire head is full of luscious locs

Photo: refinery29.com

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Cut all of the hair until it is the exact same length.

Straighten hair. (cut again if necessary)

Photo: giphy

Buy desired length of hair.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Apply Eco styling gel to hair and brush into a ponytail using a wire brush.

Using the weave, loop the 2/3 section around the 1/3 section of hair creating an interlocking loop.

Place weave over your real hair at the roots and allow natural hair to fall into the middle section of the weave.

Braid weave and hair together until the braid is completed.

Boil hot water and dip the braid into the water.

Photo: giphy

Buy desired wig.

Wash your hair thoroughly with shampoo and condition (comb hair before rinsing the conditioner out).

Section hair into 4-6 parts, comb then braid each section separately. Then blow dry thoroughly.

Cornrow (hair) straight back and place wig cap on top of braids.

Place wig on top of the wig cap and secure using clips on the wig.

Lay edges and adjust to your liking.

Photo: giphy

Cut majority of hair off.

Using clippers cut to desired to length. Using moose create finger waves. If hair is long enough, curl for a short cute look.

Photo: giphy

Shave off all of your hair

Add design in the hair or continue to brush periodically if waves are desired.

Photo: giphy